Abstract:
Pyrolysis and gasification processes were utilized in order to study the feasibility on production of value added fuels from landfilled plastic wastes. Plastic wastes were converted in a gasifier at 700900 °C. Equivalence ratio (ER) was varied from 0.40.6 with or without addition of Ni-Mg-La/Al₂O₃ catalyst. Methane was found to be the major gaseous products. The pyrolysis and gasification of plastic wastes without Ni-Mg-La/Al₂O₃ catalyst resulted in relatively low H₂ and CO with energy content ranged from 6.529.39 MJ/m³. The highest LHV obtained from 800°C and equivalence ratio of 0.4 is suitable for further usage as quality fuel gas. The maximum cold gas efficiency of 86.42% occurred at 700°C and equivalence ratios as 0.4, it would be more economical to gasify this plastic waste at lower temperature of 700°C. The residence time is one of important operating variables in the plastics gasification process. There is significant effect observed in amount or composition of gaseous products which a residence time of 1.3 s was found to be optimum in product gas with amounts of H₂ and CO. The presence of the Ni-Mg-La/Al₂O₃ catalyst significantly enhanced H₂ and CO production as well as increased gas energy content to 15.7619.26 MJ/m³. Higher temperature resulted in more H₂ and CO and product gas yield which ranged from 87.2394.29%. The maximum gas yield was achieved when Ni-Mg-La/Al₂O₃ catalyst was used at 900°C; it had significant effects on product gas yield, H₂ and CO production, calorific value and cold gas efficiency and no significant effect on reduction of hydrocarbon production. Thus, thermochemical treatment of landfilled plastic wastes using gasification is a very attractive alternative for sustainable waste management