Abstract:
Production of synthesis gas from crude glycerol by thermal conversion reactions using microwave induced was studied here. Those reactions were carried out in a fixed bed quartz reactor. Silicon carbide was used as microwave absorber and became hot bed that reached the desired temperature by adjust the microwave power level. Glycerol was obtained from a local biodeisel manufacturer utilizing palm oil as raw material. The objectives were to suggest appropriate operating parameters including total inlet gas flowrate, O2/fuel ratio, temperature, amount of catalyst on support, catalyst pre-reduction and catalytic regeneration which would produce the highest syngas, C and H conversion to gas product, cold gas efficiency, LHV, and H2/CO ratio. Gaseous product was quantified by TCD-NDIR analyzer. Result showed that the optimum total inlet gas flowrate of 1L/min which yielded the highest syngas as 1.6 L/min at 1250°C and 0.25 O2/fuel ratio. Temperature over 900°C or microwave power of more than 440 watts resulted in complete H and C conversion while the effect of O2/fuel ratio was insignificant. The 1%Ni/SiC was an optimum for catalytic reaction with 3.4 times higher syngas yield than non catalytic reaction as well as 3.8 and 4.6 times greater %C and %H conversions, respectively. The catalytic reaction at 330W produced 1.8 times higher syngas than non catalytic reaction at 880W. Effect of catalytic pre-reduction and regeneration was not conclusive. From these results, the microwave-induced heating method can be considered as an efficient option for conversion of glycerol waste into high quality of syngas that is not only increasing the alternative source of clean energy but also supporting the waste management of biodiesel production manufacture.