Abstract:
The objective of this study are to design a small-scale rotary kiln using refuse-derived fuel (RDF) and to conduct the experiments to evaluate its combustion performance.The combustion performance was evaluated in terms of combustion efficiency and the massdestruction efficiency.Prior to a design of the rotary kiln, the RDF characteristics were determined andthese values were used as design criteria in calculating the kiln size, quantities of RDF andair required for combustion. From a previous study of the characteristics of the municipalsolid wastes (MSW) of Bangkok Metropolitan in the past 10 years, it was found that theaverage of MSW composition was 34% of paper, 34% of plastic, 17% of wood, 11% ofrag and 4% of rubber. The fuel used in the rotary kiln was synthesized RDF which theircomposition were based on these MSW average values. The elemental composition of thesynthesized RDF consisted of 50.6% of carbon, 6.11% of hydrogen, 42.6% of oxygen and0.69% of nitrogen.The rotary kiln was cylindrical shape, having the outside diameter of 0.65 meter,inside diameter of 0.45 meter and its length of 2.37 meter. It was laid horizontally withone side evaluated about 5 degree. The inside kiln was insulated with refractory concrete(Cast-l3ES) lining for 10 centimeter thickness. The fuel feeder was installed at the kiln head. Two temperature detectors were inserted via the head and the end of the kiln. Asight glass and an ash removal slit were installed at the end of the kiln also. The overallsystem of the rotary kiln consisted of a kiln support, fuel feeder, air blower, temperaturedetectors, kiln prime mover, and a cyclone to remove any particulates entrained in the fluegas.The experiments were conducted using 3 variable parameters that affectedcombustion efficiency of the kiln: the mass air flow rate, the fuel feed rate and the kilnrotating speed. The combustion air flow rates were varied at 150, 200 and 250% of thetheoretical air. The fuels were fed at three different rates of 15, 20 and 25 k g h . Therotating speed of kiln was varied at 0.6, 0.8 and 1 rpm. During the experiment, oneparameter was varied while other parameters were kept constant. The experimental resultsshow that the suitable conditions yielding good kiln performance were as follows, the massflow rate of 250% of the Theoretical air, the fuel feed rate of 20 kgkr and the rotatingspeed of the kiln of 0.6 rpm. This suitable condition gave the combustion efficiency of96.07%, the mass destruction efficiency of 94.3%.