Abstract:
The purposes of this independent study were to 1) study the main causes of defects occurred during the grinding process using a small axle shaft, a part in an induction motor which has smaller diameter than that of the standard one, and 2) reduce these defects by implementing Six Sigma method.
The defects, occurred during the manufacturing process of the small axle shaft in the year 2015, were analyzed through the Six Sigma technique. This technique was classified into 5 phases: 1) Define - identification of the problem, 2) Measure - quantification of the problem, 3) Analyze - identification of the causes of the problem, 4) Improve - implementation and assessment of the solution, and 5) Control - maintainability and sustainability of the solution). The analyzed data showed that the root cause of the small-shaft process originated from the deterioration of the sensor part.
The results from this process improvement revealed that the amount of defects was significantly reduced from 1.48% to 0.12%, or 91.89% reduction. Moreover, the Process Capability Index (Cpk) was also improved from 0.72 to 1.30. Lastly, the probability estimation in the small shaft grinding by considering the Expected Overall Performance indicated that the PPM Total can be reduced from 14,632.08 PPM to 103.14 PPM.