Abstract:
According to the rapid technological development, the rate of energy consumption has been significantly increasing. Since Thailand is in with hot humid climate, the average outdoor temperature is quite high which heat easily conducts into the inside of building throught its envelope. High rise office building has a large amount of electrical consumption for air conditioning system. This study proposes some alternative modifications of curtain wall to reduce heat transfer into the existing high rise office buildings and to provide as a design guideline in the future based upon current technical and economical aspect. The study, first, began by surveying which form of office building has been mostly used. The rectangular shape is a common form of office building in Bangkok. Then, four alternative modifications were proposed, considering building exposure (partly and whole glazing wall panel) and usage (existing and new building). The criteria of heat transfer reduction through building envelope follow the requirement of Thailand building code (energy consumption) 1995. The influential factors of heat conduction through building envelope as building proportion (width to height), shading coefficient of glass, window to wall ratio and orientation of the building model were analyzed. Finally the results were applied to case study and compared total heat transfer through building envelope for 10-year life cycle cost (before and after envelope modification). As applied to three case study office buildings, it shows that for the whole glazing by adding 10 mm. of clear glass and 9 mm. of gypsum is not appropriate since the total heat reduction is only 30 percent but the cost of modification is quite high. By adding 50 mm. fiberglass material behind the glass can reduce the total heat gain about 50 percent, payback with in 5 year, and also meet the minimum regulation requirement. For the partly glazing wall panel, the most appropriate remodeling is to add 50 mm. Fiberglass material behind cladding wall. The window to wall ratio from 0 to 70 percent reduces heat gain from 77 to 23 percent after the modification. In case of the window to wall ratio more than 70 percent, the heat gain through building envelope before and after modification are similar.