Abstract:
Glass infiltrated ceramic (In-Ceram) is categorized in the high strength dental ceramics. It can be used as substructure for all ceramic crowns and bridges. For the proper strength and esthetics of restorations, 1.2-1.5 mm. tooth reduction for all axial wall was recommended, as to provide enough space for the In-Ceram layer; 0.5 mm. and for the porcelain veneer layer; 0.7-1.0 mm. Practically, to reduce 1.5 mm. thickness of tooth material may prejudice other situations. Particularly, at the lingual surface of anterior teeth where esthetic is not critical, such required tooth reduction especially for porcelain veneer layer might be unnecessary. The objective of this study was to evaluate the fracture resistance of In-Ceram crown with different lingual porcelain veneer thickness. Three groups of 10 upper incisor In-Ceram crowns were fabricated. Group I samples had 1.0 mm. lingual porcelain veneer thickness where group II had 0.3 mm. thickness and group III had only glazing layer without lingual porcelain veneer. All crowns were cemented on Cobalt-Chromium dies with resin cement. A mechanical loading directed 135 degrees to long axis of crowns was applied on the incisal thirds of them until the failure was occurred. The failure load found were (x +_ SD Newton) 789.82 +_ 67, 705.23 +_ 146, and 524.06 +_ 90 for group I, II, and III, respectively. ANOVA and Scheffe's statistical analyses revealed that there was no significant difference of fracture resistance between group I and group II and both of them showed higher statistically significant (p<0.05) fracture resistance than group III. In conclusion, regarding the fracture resistance, the presence of lingual porcelain veneer is essential but the difference was not found between 0.3 and 1.0 mm. of the veneer thickness.