Abstract:
This thesis aims to study interface friction between clay and underground structural materails, including influence of reduced interface friction by lubricant. The experimental study has been conducted based on the direct shear test apparatus with a specific modification. Whereas, the experiment condition were under consolidated undrained test. Additionally, clay samples were manually made by the reconstitued method and applying 1-ksc normal stress. Remolded clay samples were collected around Bangkok area at the level 1 to 3 meters from ground surface. The materials representing the underground structures are selected to be concrete and steel, in which, each of them were classified into two categories, smooth and rough surfaces. Moreover, bentonite slurry was chosen to be lubricant for the study on influence of reduced friction, however, in this regard, only rough concrete and smooth steel are carried out. On every test, to understand the failure zone and failure profile occurring in the soil samples, many pieces of pencil lead were used as an experimental tool to initially penetrate into the soil samples before shearing. The normal stress, type of materials, surface roughness are found to have an influence to interface friction. During the tests of interface friction under the conditions of rough surface concrete, smooth surface concrete and rough surface steel, the shear occurred inside the soil sample instead of at the interface, therefore the values of interface friction are very closed to the shear strength of clay. While, in the case of smooth surface steel shear occurred at the interface, then the interface friction is comparatively less than the shear strength. The two types of shear occurrence, inside the soil sample and at the interface, can be understood easily by the movement of pencil leads penetrated into the soil sampler, if the shear occurred inside the soil, the pencil will bent. The experimental observation is also found that the vertical displacement during shearing is initially no change or little dilated, and then settlement will start. The order of magnitude of settlement depends on normal stress, type of structural materials, surface roughness and shear rate. For the experiment about the reduced interface friction by lubricant, it is found that bentonite slurry can reduce the interface friction between soil and structural materials and settlement during shearing can be shorten approximately 30 percents, as well.