Abstract:
Objectives Biomechanic theory has been widely accepted in explaining the etiology of abfraction lesion. However, some controversial points still remain. Most of previous studies focused on the externnal environment including direction and magnitude of force while certain researches were interested in anatomical factors of tooth and alveolar bone. This study was to investigate the variations in stress at cervical area under different anatomical factors : cuspal angulation, alveolar bone level and periodontal ligament (PDL) thickness by using of 2 dimensional finite element analysis (2D FEA). Materials and Methods 2D FEA model of maxillary first premolar with anatomically average size : buccal cusp 42 ํ lingual cusp 35 ํ, alveolar bone level below CEJ 2 mm. and PDL thickness 0.2 mm. was performed by using MSC/Nastran for Windows as standard model. Three various anatomic factors which were altered by increasing and decreasing cuspal angulation 5 degree for each cusp, variation of alveolar bone level 1-4 mm. and PDL thickness 0.2-0.4 mm. All models were loaded with 500 N in different force directions which load to inner incline plane of buccal and lingual cusp. All materials were assumed to be linear elastic, homogeneous, isotropic and perfectly bonded between the interfaces. Results Non axial force appeared to caused more tensile stress than that of the axial one. The highest stress concentration was founded around cervical area. The stress was shown to decrease considerably when the cuspal angulation or the alveolar bone level was lowered, while alteration of PDL thickness seemed to have very little effect.