Abstract:
The study aims to explore the interface friction test between the reconstitued clay and structural materials. The reconstitued clay used in this experiment was originally Bangkok Clay, collected at the depth of 1-3 m below the ground surface. After oven dried, it was thoroughly mixed to form batches of clay powder. The clay powder was then mixed with water to form clay slurry which was re-consolidated in a one-dimensional cell at sigma'v = 1.0 kg/cm2. The structural materials considered were rough concrete, smooth concrete, rough steel and smooth steel. The lubricants, which were used to reduce interface friction, were the bentonite slurry, coal tar epoxy, lubricant oil and grease. It was found that the maximum coefficient values of interface friction (tan delta) between clay and concretes range between 0.33 to 0.40, and the values at interface between clay and steel are between 0.28 to 0.33. The maximum friction coefficient of interface between clay and structural materials are 12-85% less than that obtained from the drained shear strength of clay. Using the lubricants to reduce the interface friction, the grease could reduce the maximum interface friction to 80% of which was not lubricated; the bentonite slurry could reduce to about 25%. The vertical displacement value occurred during clay-clay shearing is larger than the value obtained during interface shearing.