แจ้งเอกสารไม่ครบถ้วน, ไม่ตรงกับชื่อเรื่อง หรือมีข้อผิดพลาดเกี่ยวกับเอกสาร ติดต่อที่นี่ ==>
หากไม่มีอีเมลผู้รับให้กรอก thailis-noc@uni.net.th ติดต่อเจ้าหน้าที่เจ้าของเอกสาร กรณีเอกสารไม่ครบหรือไม่ตรง

Preparation of Poly (methacrylic acid-co-N-(hydroxymethyl)acrylamide)-Grafted deproteinized natural rubber : effects of solid content on chemical and physical properties

Organization : Suranaree University of Technology. Institute of Engineering

Organization : Suranaree University of Technology. Institute of Engineering

Organization : Suranaree University of Technology. Institute of Engineering

Organization : Suranaree University of Technology. Institute of Engineering
Email : charuk@sut.ac.th

Organization : Suranaree University of Technology. Institute of Engineering
Email : yupa@sut.ac.th
keyword: Shear thickening fluids
LCSH: Non-Newtonian fluids
; Silica nanoparticles
LCSH: Nanocomposites (Materials)
; Nanocellulose
Abstract: The shear thickening fluid (STF) is a non-Newtonian fluid that transitions from shear thinning to shear thickening, resembling solid-like behavior when subjected to a critical shear rate. This research focused on developing nano silica-based shear thickening fluid (STF) and investigating the effects of silica content, media, and the addition of nanocellulose (NC) on its rheological behavior. The optimum formulation of STFs with low critical shear rate and high viscosity was determined using a parallel plate rheometer. The results showed that the fluid prepared from nano silica in PEG with a molar mass of 200 (PEG200) with the addition of nano silica at least 25% wt showed the shear thickening behavior. As the amount of nano silica increased from 25% wt to 40% wt, the peak viscosity enhanced from 10.7 Pa·s to 333.3 Pa·s, and the critical shear rate decreased from 316.3 1/s to 31.6 1/s. The critical shear rate was reduced when using PEG with higher molar mass (PEG400) as media instead of PEG200, but it increased when using glycerol. The addition of NC in STFs could enhance the sensitivity of STFs to the applied loads. The critical shear rate of the NC-modified STF was lower than that of unmodified STFs. This result could be explained by the H-bonding interaction of NC and silica, which led to the readily silica hydrocluster that reduced the critical shear rate
King Mongkut's University of Technology North Bangkok. Central Library
Address: BANGKOK
Email: library@kmutnb.ac.th
Created: 2025
Modified: 2025-10-29
Issued: 2025-10-29
บทความ/Article
application/pdf
BibliograpyCitation : In The Chemical Society of Thailand under the Patronage of Professor Dr. Her Royal Highness Princess Chulabhorn Krom Phra Srisavangavadhana and Suranaree University of Technology. Institute of Science. School of Chemistry. Pure and Applied Chemistry International Conference 2025 (PACCON 2025) (pp.705-712). Bangkok : The Chemical Society of Thailand under the Patronage of Professor Dr. Her Royal Highness Princess Chulabhorn Krom Phra Srisavangavadhana in association with the School of Chemistry, Institute of Science, Suranaree University of Technology, 2025
eng
©copyrights King Mongkut's University of Technology North Bangkok
RightsAccess:
ลำดับที่.ชื่อแฟ้มข้อมูล ขนาดแฟ้มข้อมูลจำนวนเข้าถึง วัน-เวลาเข้าถึงล่าสุด
1 PACCON 2025pp.705-712.pdf 917.87 KB
ใช้เวลา
0.037308 วินาที

Pichaya Rumjuan
Title Contributor Type
Preparation of Poly (methacrylic acid-co-N-(hydroxymethyl)acrylamide)-Grafted deproteinized natural rubber : effects of solid content on chemical and physical properties
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Pichaya Rumjuan;Wachirabhorn Pongputthipat;Pranee Chumsamrong;Chaiwat Ruksakulpiwat;Yupaporn Ruksakulpiwat

บทความ/Article
Wachirabhorn Pongputthipat
Title Contributor Type
Preparation of Poly (methacrylic acid-co-N-(hydroxymethyl)acrylamide)-Grafted deproteinized natural rubber : effects of solid content on chemical and physical properties
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Pichaya Rumjuan;Wachirabhorn Pongputthipat;Pranee Chumsamrong;Chaiwat Ruksakulpiwat;Yupaporn Ruksakulpiwat

บทความ/Article
Pranee Chumsamrong
Title Contributor Type
Preparation of Poly (methacrylic acid-co-N-(hydroxymethyl)acrylamide)-Grafted deproteinized natural rubber : effects of solid content on chemical and physical properties
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Pichaya Rumjuan;Wachirabhorn Pongputthipat;Pranee Chumsamrong;Chaiwat Ruksakulpiwat;Yupaporn Ruksakulpiwat

บทความ/Article
Strengthening natural rubber with activated carbon from cassava rhizome waste cure characteristics, physical, thermal, and mechanical properties
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Natkrita Prasoetsopha.;Patcharapon Somdee.;Nuan La-ong Srakaew.;Kanokon Nuilek.;Witawat Singsang.;Pristanuch Masakul.;Pranee Chumsamrong.;Ing-orn Sittitanado.

บทความ/Article
Toughness and thermal properties of poly(lactic acid)/natural rubber/poly(D-lactic acid) blends: Before and after annealing
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Wachirabhorn Pongputtipat;Yupaporn Ruksakulpiwat;Pranee Chumsamrong

บทความ/Article
Effects of modified silicon carbide on the physical properties of bioplastic blends
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Natkrita Prasoetsopha.;Patcharapon Somdee.;Manjunath Shettar.;Manauwar Ali Ansari.;Pranee Chumsamrong.

บทความ/Article
Chaiwat Ruksakulpiwat
Title Contributor Type
Preparation of Poly (methacrylic acid-co-N-(hydroxymethyl)acrylamide)-Grafted deproteinized natural rubber : effects of solid content on chemical and physical properties
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Pichaya Rumjuan;Wachirabhorn Pongputthipat;Pranee Chumsamrong;Chaiwat Ruksakulpiwat;Yupaporn Ruksakulpiwat

บทความ/Article
Yupaporn Ruksakulpiwat
Title Contributor Type
Preparation of Poly (methacrylic acid-co-N-(hydroxymethyl)acrylamide)-Grafted deproteinized natural rubber : effects of solid content on chemical and physical properties
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Pichaya Rumjuan;Wachirabhorn Pongputthipat;Pranee Chumsamrong;Chaiwat Ruksakulpiwat;Yupaporn Ruksakulpiwat

บทความ/Article
Toughness and thermal properties of poly(lactic acid)/natural rubber/poly(D-lactic acid) blends: Before and after annealing
มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ
Wachirabhorn Pongputtipat;Yupaporn Ruksakulpiwat;Pranee Chumsamrong

บทความ/Article
Copyright 2000 - 2026 ThaiLIS Digital Collection Working Group. All rights reserved.
ThaiLIS is Thailand Library Integrated System
สนับสนุนโดย สำนักงานบริหารเทคโนโลยีสารสนเทศเพื่อพัฒนาการศึกษา
กระทรวงการอุดมศึกษา วิทยาศาสตร์ วิจัยและนวัตกรรม
328 ถ.ศรีอยุธยา แขวง ทุ่งพญาไท เขต ราชเทวี กรุงเทพ 10400 โทร. โทร. 02-232-4000
กำลัง ออน์ไลน์
ภายในเครือข่าย ThaiLIS จำนวน 91
ภายนอกเครือข่าย ThaiLIS จำนวน 5,101
รวม 5,192 คน

More info..
นอก ThaiLIS = 265,808 ครั้ง
มหาวิทยาลัยสังกัดทบวงเดิม = 2,774 ครั้ง
มหาวิทยาลัยราชภัฏ = 35 ครั้ง
มหาวิทยาลัยเทคโนโลยีราชมงคล = 6 ครั้ง
มหาวิทยาลัยเอกชน = 6 ครั้ง
มหาวิทยาลัยการกีฬาแห่งชาติ = 2 ครั้ง
รวม 268,631 ครั้ง
Database server :
Version 2.5 Last update 1-06-2018
Power By SUSE PHP MySQL IndexData Mambo Bootstrap
มีปัญหาในการใช้งานติดต่อผ่านระบบ UniNetHelp


Server : 8.199.134
Client : Not ThaiLIS Member
From IP : 216.73.216.172